Here the source is at the receptacle and 2-conductor cable runs from there to SW1. The hot source is spliced to a pigtail that connect to the bottom, always-hot, half on the receptacle and to the white cable wire which continues on to the bottom terminal on SW1. The black cable wire is connected to the top terminal on the split receptacle and runs to the top terminal on SW1. The circuit neutral wire is connected to one of the neutral terminals on the receptacle, it doesn’t run to the switch.
This page contains wiring diagrams for most household receptacle you will encounter including grounded and ungrounded duplex outlets, ground fault circuit interrupters (GFCI) as well as 20amp, 30amp and 50amp receptacles for 120 volt and 240 volt circuits.
This diagram illustrates the wiring for a split receptacle with the top half controlled by SW1 and the bottom half always hot. The receptacle is split by breaking the connecting tab between the two, brass colored terminals. The tab between the neutral, silver terminals should remain intact.
This is the oldest version of a wall receptacle that you will find. It lacks a grounding contact and the plug slots are both the same size. These devices did not make use of a ground wire and both plug slots were treated the same. The wires used with these receptacles were usually both black.
site,please contact and we will take action immediately, we will either remove the pictures soon.Contact • Copyright • Privacy • Terms
Copyright © 2018 Hotelshostels.com. All Rights Reserved.