Here the source is at SW1 and the light fixture comes immediately after. The source neutral is spliced through to the light fixture. At the light the travelers are splice together and run to the 4-way switch. At the 4-way, the hot wire from the common terminal on SW2 is splice through to the hot on the light fixture.
A rheostat, or dimmer, makes it possible to vary the current flowing to a light fixture thereby varying the intensity of the light. The dimmer switch will have stranded wires that must be sliced to the solid cable wiring with a pigtail. A device like this should only be used with an incandescent light fixture and not with a ceiling fan or other motor. See wiring a speed controller for wiring a rheostat to control fan speed.
To wire this circuit, 2-conductor cable runs from the dimmer to the light. The source is at the dimmer and the hot wire is spliced to one hot wire on the device. The other wire from the dimmer is spliced to the black cable wire which runs on to the hot terminal on the light. The source neutral wire is spliced to the white cable wire which continues on to the neutral terminal on the light.
A 20 amp, 120v duplex receptacle like this should be installed in a circuit using 12 awg or larger cable and a 20 amp circuit breaker. These receptacles are usually found in kitchen wall outlets where two branch circuits are needed to serve small appliances and a refrigerator.
site,please contact and we will take action immediately, we will either remove the pictures soon.Contact • Copyright • Privacy • Terms
Copyright © 2018 Hotelshostels.com. All Rights Reserved.