This is the wiring for a dimmer in a 4 way circuit. To make this circuit work, a 3 way dimmer is used in place of one or both of the standard 3 way switches. A dimmer can be added in this way to any of the circuits on this page. A 3 way dimmer has 4 wires: one common, two travelers and a ground.
In this diagram the source for the circuit is at the light fixture and the two switches come after. Two-wire cable runs from the light, to SW1 and 3-wire cable runs between SW1 and SW2. The hot source is spliced to the white cable-wire, which is wrapped with black tape to mark it as hot and run through to SW1 where it is spliced to the black wire running to the common terminal on SW2. The hot terminal on the light fixture is connected to the common terminal on SW1. The red wire and marked white wire travelers connect the traveler terminals between the two switches.
In this diagram the source is at SW1 and the hot is connected to the common terminal there. Three-wire cable runs between the switches and 2-wire cable runs from the dimmer to the light fixture. The travelers from SW1 run to T1 on the 4 way switch and from T2 to the traveler wires on the dimmer. The dimmer common wire is spliced to the hot terminal on the light.
If the switch is good and things still don’t work, check the wiring to be sure the hot source is connected to a common terminal and the light fixture hot is connected to a common terminal. Likewise, be sure the traveler terminals are connected between switches only and not to any hot wires or the load.
site,please contact and we will take action immediately, we will either remove the pictures soon.Contact • Copyright • Privacy • Terms
Copyright © 2018 Hotelshostels.com. All Rights Reserved.