The traveler wires are run using the other 2-wire cable between the lights and continue on to the traveler terminals on SW2. They don’t connect to the fixtures at all.
Instead of terminals, a 3 way dimmer has 4 wires coming out of the casing: one common, two travelers and one ground wire. The common wire is usually black and the travelers red. In any case, the traveler wires will usually be the same color to distinguish them from the common wire.
Check to be sure the traveler wires only connect between the traveler terminals on the switches. Also be sure the neutral from the source is connected to the neutral terminal at the light. A neutral wire will not be used with these switches, although some smart switches may make use of a neutral wire to operate the device.
Here a receptacle outlet is controlled with a single-pole switch. This is commonly used to turn a table lamp on and off when entering a room. In this diagram, 2-conductor cable runs between SW1 and the outlet. The source is at SW1 and the hot wire is connected to the bottom terminal there. The top terminal is connected to the black cable wire running to the hot terminal on the receptacle and the source neutral is spliced with the white cable wire which runs on to the neutral on the receptacle.
site,please contact and we will take action immediately, we will either remove the pictures soon.Contact • Copyright • Privacy • Terms
Copyright © 2018 Hotelshostels.com. All Rights Reserved.