The neutral wire provides a return path for the circuit and the ground wire provides extra protection from electrocution not found on older 30 amp, 240 volt appliance hookups.
In this diagram the source is at SW1 and the hot is connected to the common terminal there. Three-wire cable runs between the switches and 2-wire cable runs from the dimmer to the light fixture. The travelers from SW1 run to T1 on the 4 way switch and from T2 to the traveler wires on the dimmer. The dimmer common wire is spliced to the hot terminal on the light.
Source 1 comes in at the light fixture and a 3-wire cable is run from there to the switch half on the device. The hot from the source is spliced to the black wire and to the input side of the switch at the other end. The white neutral from the source is connected directly to the light fixture. The red wire from the switch output goes to the hot terminal on the light.
A 4 way switch must be wired between two 3 ways as shown in the diagrams on this page. A 4 way has five connections: one ground, and 4 circuit terminals divided into two matching pairs. Each pair of terminals should be wired to the traveler wires from one of the 3 way switches. The travelers can be wired to either terminal in a pair, but don’t mix up the pairs or the circuit won’t work properly.
site,please contact and we will take action immediately, we will either remove the pictures soon.Contact • Copyright • Privacy • Terms
Copyright © 2018 Hotelshostels.com. All Rights Reserved.