A 4 way switch must be wired between two 3 ways as shown in the diagrams on this page. A 4 way has five connections: one ground, and 4 circuit terminals divided into two matching pairs. Each pair of terminals should be wired to the traveler wires from one of the 3 way switches. The travelers can be wired to either terminal in a pair, but don’t mix up the pairs or the circuit won’t work properly.
This diagram is the same as the one above but the dimmer comes first in the circuit. This arrangement is provided for easy reference when dealing with a circuit wired like this.
This is another option for wiring a combo device where two sources are used. In this arrangement the connecting tab between the hot terminals on the device is broken off to separate the two. The switch controls a light and the receptacle half of the combo device is always hot.
The traveler terminals will always be connected from switch to switch. Travelers never connect to a device load or to a source wire. It doesn’t matter which traveler terminal is used for which traveler wire, reversing them should make no difference.
site,please contact and we will take action immediately, we will either remove the pictures soon.Contact • Copyright • Privacy • Terms
Copyright © 2018 Hotelshostels.com. All Rights Reserved.